Panel Load Calculator
Enter your house size and the big loads you run and see the amps you need and how much of a 100, 150 or 200 amp service they use.

Saved. It will travel with your request below.
A simplified estimate in the spirit of the standard load calculation: three volt-amps per square foot plus small-appliance and laundry circuits, with the general load counted in full for the first ten thousand and at forty percent beyond that, then the big loads you pick at full value. The real calculation has more rules, and we do it on your own house.
Three quick steps
- 1Set the houseLiving area in square feet.
- 2Pick the big loadsRange, dryer, heater, A/C and more.
- 3Read the loadAmps and percent of service.
About the panel load calculator
How is the load figured?
Three volt-amps per square foot plus small-appliance and laundry circuits, with the general load counted in full for the first ten thousand and at forty percent beyond that, then the big loads you pick at full value, divided by 240 volts.
Is this the official load calculation?
No. It is a simplified estimate. The official calculation has more rules, and we do it on your own house.
What does it mean if I am over?
It means the loads you listed could ask for more than the service can give. An upgrade, a load-management device or fewer loads at once are the usual answers.
Services that go with this tool
Electrical Panel UpgradesOld fuse boxes and crowded 100 amp panels replaced with a modern 200 amp panel that can carry today's loads.See the service Panels
Service Entrance UpgradeNew mast, meter base and service cable sized for 200 amps or more, with the utility handling the connection.See the service Panels
Sub-Panel InstallationA second panel in the garage, shop, addition or basement that gives you room for new circuits close to where you need them.See the service Ready to get the power right?
Call or text Electrical Illusions, or send the form, and we will set up a visit. Tell us about the house or building and what you need done.

