Skip to content
EV, Generators and Power

EV Charger Installation

A wall charger gives you a full battery every morning. We check your panel, size the circuit, run the wire and mount the charger where the cable reaches, then test it with your car. The EV Charger Planner on this site shows how long a charge takes.

EV Charger Installation by Electrical Illusions
  • ChargerLevel 2, 240 volt, hardwired or plug-in
  • CircuitBreaker at 125 percent of the charge rate
  • LocationGarage, carport or driveway
  • ResultA full battery by morning
What you get

What is included

  1. 1Panel checked firstWe calculate your load before adding a charger, and tell you if a panel upgrade or load-management device makes sense.
  2. 2Circuit sized correctlyA 40 amp charger gets a 50 amp breaker and the right wire, because the charge counts as a continuous load.
  3. 3Mounted where the cable reachesWe place the charger by your parking spot and route the wire neatly and safely.
  4. 4Permit and rebatesWe pull the permit and tell you about utility programs that may help pay for the install.
How it works

From your first call to the finished job

We do electrical work in cities across the country. Find yours below and set up a visit.

  1. 1You reach outCall, text or send the form with your city and what you are adding: a car, a generator, a spa or a pump.
  2. 2We size the circuitWe read the nameplate and check your panel's capacity before we plan.
  3. 3We install to codeWire, breaker, disconnects and protection go in, permitted and inspected.
  4. 4We commission and explainThe equipment is tested under load and you learn how it works and how to keep it safe.
Good fit when

Is this the right choice for your property?

  • Owners of electric and plug-in cars
  • Homes planning to buy one
  • Garages and carports with no 240 volt outlet
  • Condos and rentals working with the owner on charging
Good to know

What makes big power safe

  • Sized from the nameplateCircuits for chargers, spas, pumps and appliances come from the equipment's rating.
  • Disconnects and protectionEquipment gets the disconnect and GFCI protection the code asks for.
  • Panel checked firstWe check that the panel can carry the new load before anything is ordered.
Questions

Common questions

What size circuit does my EV need?

Home chargers commonly run from 16 to 80 amps. The breaker is sized at 125 percent of the charger, so a 40 amp charger needs a 50 amp breaker. We match it to your car and panel.

Can I just use a regular outlet?

A standard outlet adds only a few miles of range per hour. A 240 volt charger adds many more and is worth installing if you drive daily.

Where we work

Find your city

Type your city or neighborhood to open the page for help near you.

Start typing, for example a city name or a neighborhood.

    Ready to get the power right?

    Call or text Electrical Illusions, or send the form, and we will set up a visit. Tell us about the house or building and what you need done.

    Visit

    Let's get your power working right.

    Tell us what is happening or what you want added. We read every message and reply with clear next steps and a time for your visit.

    • Your property: where it is, how old the wiring is and what you want done
    • Your city, the job you have in mind, and any result you saved from a tool on this site
    • A visit where we look at your panel and wiring, test what we can and begin a plan around what you want
    Prefer to talk? Call or text800-224-9245

    Your estimate request

    Prefer to type? Text your request. We only use your details to respond to your request.